The light test after installation of fiber laser cutting machine-Tulsa
According to the laser power process, turn on the laser control. Click the button, test the laser light output. Note that the water cooler must be turn on before the test. So that the oxygen and nitrogen gas can discharged normally.
Under normal circumstances, you need to turn on the water cooler first and then turn on the fiber optic device. When the water cooler and fiber optic device standby, turn on switch knob of the water cooler first. Then turn on the key switch and the switch button of the fiber optic device after the water normal.
Because there are many brands and models of optical fiber devices, other detailed operations will not be listed. If you are unclear, please contact our company.
However, pay attention to the following points:
1. When the water temperature is low, you need to wait for the water temperature to rise to 20°C. Before turning on the optical fiber device. 2. Due to the different models of the water cooler, after turning off the knob. You need to click the start button on the panel again for the water cooler to work. 3. The operation method is slightly different due to the power, brand and model of the optical fiber device. For example, there are no buttons on the 500W-1000W IPG optical fiber device. And its key switch and switch button are integrate into the operating software. For a higher-power fiber optic device. You need to turn on the key switch of fiber optic device or turn on the handle switch. Let the dehumidification device of the fiber optic device work for ten minutes. Then turn on the water cooler and run to certain temperature. And then let the fiber optic device emit light .
For example, for a Max optical fiber device below 1000W, after unscrewing the key switch on the optical fiber device. Wait a few seconds and click START, then the red light will be emitte. Then click the “Shutter” button in the software, click the “Shutter” nozzle, laser will be emitte. For another example, in some optical fiber optics, after turning off the key switch (or turning the key switch to REM) and clicking START (or without clicking). You need to click “Shutter” in the software, then click the Aiming and Laser buttons.