Safe operating procedures for laser cutting machine-Yan

FOR OPERATORS

1.Observe the general safety operation regulations of Laser CNC Equipment. Start the laser machine strictly in accordance with the laser machine startup procedure.

2. Operators should familiar with the structure and performance of the equipment and to master the knowledge of the operating system.

3. Wear labor protection equipment according to regulations, and must wear protective glasses that meet the regulations near the laser beam.

4. Do not process a material before it is clear.

FOR MACHINE

1. When the equipment is started, the operator shall not leave the post or be taken care of without authorization. BUT if it is necessary to leave, stop the machine or cut off the power switch.

2. Keep the fire extinguisher within easy reach;then turn off the laser or shutter when not working; and do not place paper, cloth or other flammable materials near the unprotected laser beam.

3. When an abnormality is found during processing, the machine should be shut down immediately, and the fault should be eliminated or reported to the supervisor.

4. Keep the laser, the bed and the surrounding area clean, orderly, and free of oil pollution, and stack the workpieces, plates, and waste materials as required.

5. When using gas cylinders, avoid crushing the welding wires to avoid leakage accidents. The use and transportation of gas cylinders should comply with gas cylinder supervision regulations. It is forbidden to explode gas cylinders in the sun or close to heat sources. When opening the bottle valve, the operator must stand on the side of the bottle mouth.

6. Observe high-voltage safety regulations when repairing. Every 40 hours of operation or weekly maintenance, every 1,000 hours of operation or every six months of maintenance shall be carried out in accordance with regulations and procedures.

AFTER STARTING

1. After starting the machine, manually start the machine in the X and Y directions at low speed, and check whether there is any abnormality.

2. After inputting the new part program, test run it first and check its operation.

3. When working, pay attention to observe the operation of the machine tool to avoid accidents caused by the cutting machine going out of the effective stroke range or two collisions.

  A piece of laser cutting machine equipment is tens of thousands or even hundreds of thousands, so you must pay attention to it in operation, and usually pay attention to maintenance and maintenance to increase the service life of the equipment, save costs, and create greater benefits.

Yan

Sales Consultant

CEL/Whatsapp:008615263244727