Nine standards for laser cutting machine cutting quality judgment-Teresa

 Nine standards for laser cutting machine cutting quality judgment

Judging the quality of the laser cutting machine is the best way to judge the performance of the laser cutting equipment intuitively. Here are some of the nine criteria for judging.

1. Roughness.

The laser cutting section will form vertical lines. The depth of the lines determines the roughness of the cutting surface. The lighter the lines, the smoother the cutting surface. Roughness affects not only the appearance of the edges, but also the friction characteristics. In most cases, it is necessary to reduce the roughness as much as possible, so the shallower the texture, the higher the cutting quality.

2. Verticality.

If the thickness of the sheet metal exceeds 10mm, the verticality of the cutting edge is very important. As you move away from the focus, the laser beam becomes divergent, and depending on the position of the focus, the cut becomes wider toward the top or bottom. The cutting edge is a few millimeters from the vertical line. The more vertical the edge, the higher the cutting quality.

3. Cutting width.

Generally speaking, the cut width does not affect the cutting quality. Only when a particularly precise contour is formed inside the part, the cutting width has an important effect. This is because the cutting width determines the minimum inner diameter of the contour. Increase. Therefore, we want to ensure the same high accuracy, regardless of the width of the cut, the workpiece should be constant in the processing area of ​​the laser cutting machine.

4. Lines.

When cutting thick plates at high speeds, the molten metal does not appear in the cuts under the vertical laser beam, but instead sprays out at the rear of the laser beam. As a result, curved lines are formed at the cutting edge, and the lines closely follow the moving laser beam. To correct this problem, reducing the feed rate at the end of the cutting process can greatly eliminate the formation of lines.

5. Glitch.

The formation of burrs is a very important influencing factor in determining the quality of laser cutting. Because the removal of burrs requires additional work, the severity and amount of burrs can intuitively judge the cutting quality.

6. Material deposition.

The laser cutting machine encounters a special oily liquid on the surface of the workpiece before it starts melting the perforations. During the cutting process, because the gasification and various materials are not used, the customer uses wind to remove the cuts, but the upward or downward discharge will also cause deposits on the surface.

7. Sagging and corrosion.

Sinking and corrosion have an adverse effect on the surface of the cutting edge, affecting the appearance. They appear in cutting errors that should normally be avoided.

8. Heat affected area.

In laser cutting, the area near the cut is heated. At the same time, the structure of the metal changes. For example, some metals will harden. The heat affected area refers to the depth of the area where the internal structure changes.

9. Deformation.

If the cutting heats the part sharply, it will deform. This is especially important in fine machining, where the contours and webs are usually only a few tenths of a millimeter wide. Controlling laser power and using short laser pulses can reduce component heating and avoid distortion.

For more information ,please feel free to contact us:

Email: xintian105@xtlaser.pl

Whatsapp: +8615006829603

Skype: xtlaser Teresa