Fiber laser cutting machine details from XT Laser Wendy
Fiber laser cutting machine details
Fiber laser cutting machine details
When the laser cutting machine is working, if the failure is very dangerous, the novice must train by a professional to operate independently. And the 13 details of the safe operation of the laser cutting machine are summarize on experience:
Firstly, Observe the general safety rules of the cutting machine. Start the laser strictly in accordance with the laser startup procedure.
Secondly,The operator must train to be familiar with the structure and performance of the equipment and master operating system knowledge.
Thirdly, Wear protective clothing as require and wear protective glasses that are in compliance with the laser beam.
Fourthly, Do not process a material without knowing if it can be irradiate or heat by laser light to avoid the potential for smoke and vapor.
Fifthly, When the equipment is start, the operator must not leave the post or leave the staff to be in charge. If it is really necessary to leave, the operator should stop or cut off the power switch.
Operation details of fiber laser cutting machine
6, Keep the fire extinguisher in a position that is within easy reach; turn off the laser or shutter while not processing; do not place paper, cloth, or other flammable materials near the unprotected laser beam.
7,In the event of an abnormality in the processing, the machine should be shut down immediately, and the trouble should be promptly correct or report to the competent personnel.
8. Keep the laser, the bed, and the surrounding area clean, orderly, and free of oil. Work pieces, plates, and scraps are piled up as required.
9. When using gas cylinders, crush the welding wires should avoid leakage accidents. The use and transportation of gas cylinders should comply with gas cylinder monitoring procedures. Do not expose the cylinder to sunlight or near heat sources. When opening the bottle valve, the operator must stand on the side of the bottle mouth.
10. Observe high pressure safety regulations when servicing. Every 40 hours of operation or weekly maintenance, every 1000 hours of operation, or every six months of maintenance, should be performed in accordance with regulations and procedures.
11. After turning on the machine, manually start the machine at low speed in X and Y direction to check if there is any abnormality.
12. After a new part program is entered, it should be tested and its operation checked.
13. When working, pay attention to observe the operation of the machine tool to avoid the cutting machine getting out of the effective range or two collisions causing accidents.
More details contact us:
Email:xintian112@xtlaser.pl
Whatsapp:+8613176671529