Disadvantages of continuous full load or overload cutting
Metal laser cutting machine equipment is relatively expensive equipment, and the selected power is different, the price will vary greatly, in general, the greater the power of the laser cutting machine selected, the higher the price of the equipment. Therefore, many users will choose devices with lower power when choosing devices, so as to achieve the purpose of saving costs. However, in daily production and processing, if it is necessary to use a laser cutting machine to continuously cut thicker plates, long-term use of the laser cutting equipment at full load or overload will cause considerable damage to the laser cutting equipment, which will reduce the laser to a certain extent Life.
The main loss of metal laser cutting machine at full load or high load operation is the following components:
Laser chiller: the chiller starts and stops high-frequency operation, which consumes a lot of its internal compressor and main components, which will shorten the service life of the chiller.
Laser and lens: There is a certain time limit for the replacement of consumables. If used for a long time, the replacement cycle will be shortened.
Laser power supply: using full power is like a car running 120 yards for a long time. It is easy to cause damage to the motor. Anything will be damaged faster if it is used for a long time. The same is true for laser cutting machines.
In addition to the components mentioned above, if the metal laser cutting machine runs under high load for a long time without stopping, other accessories will be more or less damaged. If you need to process thick plates or require long-term operation of the equipment, it is best to choose the power Configure higher equipment, otherwise the probability of equipment failure during use will be relatively higher than that of normal operating equipment.
XT laser is manufacturer of laser machines since 2004, any inquiry, feel free to contact us: