Automatic coil fiber laser cutting machine common problems – Catherine

Automatic coil fiber laser cutting machine common problems

Now pipe fiber laser cutting machine is hot selling, and with the technology improve, most of our customers want to use the automatic coil. You can check solution to automatic coil fiber laser cutting machine common problems:

1. Cutting perforation technology

For each type of thermal cutting technology, only a few cases can start from the edge of the board. In general, a small hole must worn in the board. Previously use on laser stamping laminators, the punch first punched out a hole. And then laser cut from the small hole.

2. Analysis of deformation of small holes (diameter and thickness)

In the processing of small holes, instead of using blasting and perforation, pulse perforation use. As a result, the laser energy too concentrate in a small area. So that the non-processed area also burnt, thereby causing deformation of the hole and affecting it. The quality of processing. At this time, we should change the pulse perforation method to the blasting and perforation method in the machining program to solve it. For the smaller power laser cutting machine, the opposite is true. In the small hole processing, pulse perforation should adopt to obtain a better surface finish.

3. When laser cutting low carbon steel, the solution to the burr of the workpiece

According to the work and design principle of the automatic coil fiber laser cutting machine, the following reasons are the main reasons for the burr of the workpiece: the upper and lower positions of the laser focus are not correct. And the focus position test needs to done according to the focus. The shift amount adjust, the output power of the laser is not enough. It is necessary to check whether the laser generator works normally. If it is normal, observe whether the output value of the laser control button is correct, adjust it, the cutting line speed is too slow. And it needs to be in operation control. Increase the line speed.